R and V Works FF6 Informations techniques télécharger pdf (Page 43)

Compressor Application Manual

• Braze the filter into the condenser and capillary.

Do not unnecessarily heat the body of the filter

dryer, and take great care not to block the tubes.

• Install the fast coupling to make a vacuum on

the high pressure side;

• The filter dryer must be installed in the vertical

position with the capillary at the bottom

(see figure 29).

This position prevents the desiccant grains from

rubbing and releasing residues. It also helps

equalize a pressure faster (capillary systems).

Figure 29 - Filter Drier

The system is now ready to receive

the new compressor. Install it in the

correct position and fix it to the

base. Braze the suction and

discharge tubes to the respective

compressor tubes.

Also braze a tube of approximately

100 mm (3.94”) to the process tube.

Capillary

Condenser

If the refrigeration system has not

been designed to use the compressor's

oil cooling tube (TRO), do not forget

to connect it. Otherwise the

compressor will have a shorter

working life.

Important

Brazing - Do not forget to clean

the surface to be brazed well.

Remember: blockage of the

outlet tube will damage the

compressor valve system.

Important

Filter Drier

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 79 80

Pas de commentaire

R and V Works FF6 Informations techniques Page 43