R and V Works FF6 Informations techniques télécharger pdf (Page 38)

Compressor Application Manual

14 - Soldering rods;

15 - Brazing flux;

16 - Vacuum gauge;

17 - Oxy-acetylene or axi-gas welding equipment;

18 - Device for checking electricity range

(multimeter, test lamp and others);

19 - Pressure/hose analyzer with retention valve;

20 - Connectors/fast couplings/hoses with manifold;

21 - Universal pliers;

22 - Small clamp

2 - How to remove a used compressor

• We recommend that the used refrigerant fluid is

collected for later recycling or incineration,

according to the following procedure:

First, install a perforating valve in the

compressor process tube. Connect the

perforating valve to the recovery equipment

that is then connected to the receiving cylinder.

Now just connect the recovery equipment.

Open the receiving cylinder valve and then the

perforating valve.

It is very important to keep the recovery

equipment operating as long as it is necessary

to collect all refrigerant. The duration of this

process will depend on the equipment used

and refrigeration system.

• Loosen the points where the compressor is fixed

to the system;

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 79 80

Pas de commentaire

R and V Works FF6 Informations techniques Page 38