R and V Works FF6 Informations techniques télécharger pdf (Page 39)

Compressor Application Manual

• Undo the connections from the electrical starting

and protection devices;

• Remove all oxidation and paint using sandpaper

(fig. 26.a) in the brazing region, to facilitate

brazing later;

• Warm the brazing region (fig. 26.b) in order to

separate the compressor from the system's

piping;

• After cooling, close off the compressor tubes and

system's tubes with rubber plugs (fig. 26.c);

• Loosen the locks that fix the compressor base to

the system.

Figure 26.a - Sand papering the tube

Figure 26.b - Separating the compressor

from the system's tubes

Figure 26.c - Closing the tubes with

rubber plugs

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 79 80

Pas de commentaire

R and V Works FF6 Informations techniques Page 39